Blade Eruptor
Is there anything special I need to do with the mining_proxy programming???
I can't seem to get my blade above 73% efficiency. mostly it sits at 63% efficiency
It doesnt seem to want to go over 6100mh/s grrr... plenty of power and fans. the fins are not hot.
I originally struggled with them not getting efficiency in 90+% and it did turn out to be lack of power. Are you using generation 1 or the new ones?
The luck in recent days pleases me.
You had to say it? Going on to 6 hours.
the newest ones. from what I read they require 10amps of 12v. I have it plugged into a 375 which can do 18amps with 2 12volt rails being used by the pc. I then connected it to a stand alone 375 same thing. tested the volts and they are all steady 12.1v so the power supply is not struggling it is delivering the 10amps. the chips: thing is all 0's which i guess means all ok?