Well I still am getting the "Running (Connect to CGMiner API failed)" error from the web GUI.
Yes, I have cleared the cash on the browser, AND used a different browser.
More importantly I can tell it isn't doing anything because the pool isn't getting much work.
Looks like 0.96 isn't up to prime time for my Mercury. Going back to 0.95 because at least that was hashing something. Unless there is something else to do to get 0.96 to work?
Thanks,
_theJestre
I have similar problems with my Saturn. Download bertmod and check the stats of your VRMs. You might have a bad unit or two. I have 3 bad VRMs out of my two boards. My guess is that with BAD VRMs you cannot update to the higher fw, probably because they are more well adjusted to work with the VRMs, and since some VRMs are not functioning [properly, or at all, like in my case], its causing the later fw to not work. The only fw I can get running stable is fw 0.9.4. Out of my Saturn, I am averaging 150gh/s.
Check with the bertmod patch, you might need to RMA the board. Or you could try all the tricks the good folks here have discussed. I've tried them all (other then disabling fans), and nothing fixed it.
Bertmod:
http://forum.kncminer.com/forum/main-category/main-forum/6183-bertmod-0-2-unofficial-firmware-mod-feedback-threadI don't know if your problem is related, but I am now starting to suspect that a little extra heat (rather than cooling) and now as of recently, tightening down (slightly) on the heat sink crossmember screws (WHICH MOST LIKELY PUSHES THE CHIP DOWN AS WELL) has improved performance ON SOME machines....I suspect on yours, and I don't know DIDDLY (other than Bo), that you will probably find some of the screws on the crossmember for the heatsink can use a little tightening.....which in turn will probably make the chip have better contact to the board, then you will notice change in VRM stats...HOPEFULLY.
Disclosure...I KNOW NOTHING.
good luck.