Can anybody tell me why phoenix.exe above 2.7c crashes in 5 seconds when starting on one rig and on my other rig it runs perfect also with latest version.
Both rigs are identical with 6 gtx1070 8gb cards each and windows 10.
I didnt read anything here about this problem.
add to start.bat file in the end -rmode 1 -nvidia -log 0 -eres 2 -coin eth if u mine ether, save and start, try
Thanks for your advice, but unfortunately phoenix keeps shuting down and dont restart if something happens.
Some times after 10 times starting Phoernix manualy, it runs untill an autorestart is needed because of some faillure and it says: phoenix.exe isnt working anymore and shuts down.
I had a similar behaviour one one of my rigs. I finally isolated it to one card running too hot after a while. Check your logs to see if one of the cards shuts itself off near the end of the log. Try reducing the overclocks and see if running a few degrees colder helps. Also check your Pagefile memory. Ensure its set high enough. good luck
The shutdown of the miner is also from the start, even with a cold card. My cards never get hotter than 58 degrees. (49-58)
The problem with shuting down appears with and without overclocking.
I will try to re-install the rig soon and see what happens.
If it is an almost instant no start then could be just bat file or epools settings is incorrect.
Check wallet address, mining worker format, mining url and port. If you have copied it from another mining rig and when you start up it has for example the same worker number from another rig it may just need to be adjusted to be indeed a new worker....