BTW...
I just ran Bertmod for the first time,
It showed all cores on all machines at 100%, except one had 3 cores on a single die...dead...
I tightened the screws a bit more on that board... (very tight)
It brought them back!!!!
Bertmod is awesome!
Now 100% on all boards!
edit...spoke too soon... they shut off one by one within two mins still...
will try to coax them back....
I just ran Bertmod for the first time,
It showed all cores on all machines at 100%, except one had 3 cores on a single die...dead...
I tightened the screws a bit more on that board... (very tight)
It brought them back!!!!
Bertmod is awesome!
Now 100% on all boards!
edit...spoke too soon... they shut off one by one within two mins still...
will try to coax them back....
I'm pretty sure Bertmod didn't do anything to bring your cores back from the dead. Bertmod just expands the stats for the KNC web GUI.
I'm quite sure he meant Bertmod was great for showing the bad cores.
Ah, ok. I misunderstood the comment. Thanks for the correction.
But also good to know the temp sensor readings are from a different location on bertmod than the normal firmware... perhaps the Bertmod Dev could add the asic temp, or KNC could add vrm temps....
Based on the vrm info.. I'm trying a few things.... details later.