Kabopar,
I found drawing a line along the side was easiest, one to two lines did it for me.
my initial scribbling over the top was not necessary :-)
i'd measure the resistance again after, I'd not let it go below 0.84.
you might need the eraser and a couple of attempts to get the right result.
Thanks for this suggestion, I just tried it and it does work, finally the resistance moved from 0.97K to 0.94K. after 4 minutes I'm getting 2.40/2.38/2.33 (bfgminer 3.5.1), which is better than anything this BF produced before. So far there is no noticeable heating, but it could be too early to tell. (It's going to be summer here soon too, hopefully the bushfires will not be ignited by overheating BlueFuries...I found drawing a line along the side was easiest, one to two lines did it for me.
my initial scribbling over the top was not necessary :-)
i'd measure the resistance again after, I'd not let it go below 0.84.
you might need the eraser and a couple of attempts to get the right result.
Cheers