The reset button on the V9's I have dont do anything. I can hold them down for over a mintue and still no beep. I formatted an SD card with FAT32 and copied the firmware files bitmain posted for the V9 Miner onto the SD card. I then inserted the SD card into the miner and turned it on. The fans started spinning at max and now both the red and green led are staying on. Ethernet light is flashing but nothing is showing up on my router. Any ideads?
you may not have incorrectly configured the static IP address address i had a V9 the Controller went up after i tried to set the static IP address a few others in this post a few pages back had the same problem, i had to get the V9 replaced.
the two i have now work great on a static IP. it doesn't happen to everyone,I believe it's the same controller used on the S9 an T 9 .. I Know for sure it is not the same controller used on the L3+ AND D3 ...
Moderator's note: This post was edited by frodocooper to remove nested quotes.