I could use a little help with resetting my blades. I've got two mining and two that I can no longer access from my browser.
Someone else built the rig for me so I am a complete newb at this.
I understand I can reset using either a jumper or even a paperclip.
Now...if someone will indulge me, I need a full step-by-step at this.
1. Which pins do I place the jumper on, and for how long? Is it the six pins by the ethernet port, or the four pins next to that?
2. How long do I hold the jumper on there for?
3. After reset, what address do I enter to config the blade? (I have my static IP at 10.0.1.2 and subnet mask at 255.255.255.0
If I can just access the config page I can get the settings back in line with my other two blades, but for now I am lost.
Thanks for any assistance.
Here is a pic of where the pins are. Just use the paperclip to jump points 2 and 3. It only needs contact for a second while the blade is on. You will see the leds turn of and on on the blade.Someone else built the rig for me so I am a complete newb at this.
I understand I can reset using either a jumper or even a paperclip.
Now...if someone will indulge me, I need a full step-by-step at this.
1. Which pins do I place the jumper on, and for how long? Is it the six pins by the ethernet port, or the four pins next to that?
2. How long do I hold the jumper on there for?
3. After reset, what address do I enter to config the blade? (I have my static IP at 10.0.1.2 and subnet mask at 255.255.255.0
If I can just access the config page I can get the settings back in line with my other two blades, but for now I am lost.
Thanks for any assistance.
After factory reset a Blade with resort to the factory IP address. http://192.168.1.254:8000
If your ip range is differnet you will need to adjust router setting to put you on the same IP range as your blade.