Just received my blade,sailed smoothly through the hardware stuff,however I'm stuck at the configuration page.
What I did was:
1)Open mining proxy(on default settings)
2)Set both the server addresses to my IP(as seen in cmd using /ipconfig)
3)Set the ports to 3333,8332
4)Set the account info to username_workername:password,username_workername:password
Now I'm getting two different results.
On port 3333,mining proxy goes batshit crazy,but the hashrate is still stuck at 0
On port 8332 nothing happens.
Would appreciate any help,thanks in advance.
What I did was:
1)Open mining proxy(on default settings)
2)Set both the server addresses to my IP(as seen in cmd using /ipconfig)
3)Set the ports to 3333,8332
4)Set the account info to username_workername:password,username_workername:password
Now I'm getting two different results.
On port 3333,mining proxy goes batshit crazy,but the hashrate is still stuck at 0
On port 8332 nothing happens.
Would appreciate any help,thanks in advance.
3333 is a sratum port, 8332 is getwork port, blades use getwork so if you use 8332 twice for your ports you should be good... Hope that helps
Tried that too,still doesn't work
Current Server: 192.168.1.X:8332
No hashes