Quote from: Sandal_Hat on May 09, 2018, 01:02:56 AM

Quote from: sattychrome on May 09, 2018, 12:01:43 AM

Quote from: coinpreacher on May 08, 2018, 09:36:10 PM

I tried, it does not work on the B3. Both fans still at max speed.

Tried this:

"bitmain-fan-ctrl" : true,
"bitmain-fan-pwm" : "50"

and

"bitmain-fan-ctrl" : true,
"bitmain-fan-pwm" : "50",

I thought a comma , was missing behind the "50" but no change ...

Guys, All I did was just remove the connector of the Exhaust fan. My chips temperature is at 35 degree and I still feel cold air coming out through the exhaust fan(I did not unmounted the fan from Miner) one fan is enough and the Noise is almost 50% less and I am happy that no disturbance from miner

That cant be right. Some of us use both fans and it is 40-50 degrees as seen in above picture. U must be in a cold place?
U have cold air due to air-con?

No Air Cond. My Basement is little cold still and that may be the reason and my chip temperature was always 30-35 degree before I removed the fan connector...but still 40-50 is still OK. All i am saying is just remove the exhaust fan connector and just try it for an hour...I see people are struggling so much to change the config or change the fans....Which I am saying is not required. Note the current chip temperature....switch off the miner...remove the exhaust fan connector...switch the machine ON and try for an hour....Just giving my experience and noise level is way far better....