Hello all,
I have been mining with a BFL 30Gh/S system and just bought an Avalon 4 Module. Tried setting it up at the office and could not get it to work with the Wifi.
I accidentally deleted the LAN config and brought it home to try and connect to my home network.
I set my Mac up to the 192.168.0.101 ip and tried using my browser to connect.... nothing - it times out.
I tried ssh from laptop - still nothing.
Is there a hard reset to restore to factory settings?
Did I brick the WR703N? If so, is my only hope to take the unit apart, solder the wire to the connection and reset?
Help!
There is a hard reset procedure, the user ckolivas describes it earlier in this thread. The instructions are also available from OpenWRT and TP-LINK on their respective websites. Note that this does not restore the Avalon factory configuration, but the base installation for the WR703N to function as a router. You will need to donwload and flash Avalon config (erroneously referred to as "firmware") from either ckolivas web repository or the Avalon wiki.