Thx jstefanop.
Testing my ten L3+ with lowest voltage (0xfe). Currently running 400 frequency.
Can this set frequency for each board individually?
for example :
board 1,2,3 running very smooth on 450 frequency & voltage 0xc0 with less HW
board 4 cant go over 400 no mater how high is voltage (0x30) , too much HW (error every sec)
I will chime in it can give multiple voltage for each board.
Not mutilple freq.
So this means you can choose freq 400 knowing the three boards are under tasked or choose say 425 and tossing lots of errors on the poor board
btw don't volt the bad board that high you will just burn it out.
personally i would swap it to a different L3+ but if you have 1 l3+ that is not an option.