Re: Official FutureBit Moonlander 2 Driver and Support Thread
I posted below questions a few days ago. I have combed through several pages in this thread and wasn't able find a clear response/hint. Nobody seems to answer or try to help. I will repeat my questions and hope somebody can respond instead of ignoring my request:
1. How do I find MLD stick current mem voltage? Is there a command (I am using terminal in apple to communicate with bfg through raspi)
2. How do I adjust clock rate? <-- Yes I know I found a command (--set MLD:clock=xxx) but I do not know where in terminal to put this command.
As you may see my MLD 1 has some issues and I want to check if voltage is causing this:
https://image.ibb.co/c9VEgJ/Screen_Shot_2018_05_17_at_09_18_02.png
I thought this was a support thread.
1. How do I find MLD stick current mem voltage? Is there a command (I am using terminal in apple to communicate with bfg through raspi)
2. How do I adjust clock rate? <-- Yes I know I found a command (--set MLD:clock=xxx) but I do not know where in terminal to put this command.
As you may see my MLD 1 has some issues and I want to check if voltage is causing this:
https://image.ibb.co/c9VEgJ/Screen_Shot_2018_05_17_at_09_18_02.png
I thought this was a support thread.
Hi guys,
I am pretty noob on the MLD, I've got two sticks mining LTC in litecoinpool using Plugable 60W 7 port USB 3 hub.
It is working.
But my issue is low average hashspeed. My 24H average 5880 KH/s. Especially one of the miners seems to be dropping to 2.3 Mh/s.
If I restart the BFG it goes up and then drops again. It often also stops hashing and then restarts automatically.
I think I mistakenly adjusted the memory voltage pot too much/too little. I am not sure what its current memory voltage is.
So I need to know where I can find its current memory voltage. Core voltage is running around .725 so that should not be the issue.
Also I do not know how to adjust clock rate. Can anyone share a command.
By the way I am running this on a raspi 0 through IOS.
Anyone can help?
Cheers and thanks a lot!
I am pretty noob on the MLD, I've got two sticks mining LTC in litecoinpool using Plugable 60W 7 port USB 3 hub.
It is working.
But my issue is low average hashspeed. My 24H average 5880 KH/s. Especially one of the miners seems to be dropping to 2.3 Mh/s.
If I restart the BFG it goes up and then drops again. It often also stops hashing and then restarts automatically.
I think I mistakenly adjusted the memory voltage pot too much/too little. I am not sure what its current memory voltage is.
So I need to know where I can find its current memory voltage. Core voltage is running around .725 so that should not be the issue.
Also I do not know how to adjust clock rate. Can anyone share a command.
By the way I am running this on a raspi 0 through IOS.
Anyone can help?
Cheers and thanks a lot!