Re: [ANN] BitenX [BTENX] [X11 | POW/MASTERNODE | Privatepay - Instapay] [Biten Swap]
Yes, I've done all of those things. Here's the problem: If I do `masternode list` on a node which doesn't have a masternode, I don't get anything returned. So, the masternode might be showing on your node, but it isn't being propagated across the network. Try it yourself, set up another node, let it sync and then try `masternode list`. See if you get anything returned or if your list is empty.
When I do a `masternode list`, I don't see the masternode that you show in your screenshot.
Also, the masternode that you set up; have you received any rewards on it?
Also, if this is a fork of Dash, do we need sentinel?
I don't know what you are doing wrong I setup masternode with guide I wrote above and when type masternode list I get this:
It synced in few minutes and now it's working.
Disable IPV6
Do you have ports open for 44445?
Do you have blockchain fully synced?
Do you have walletpassphrase?
When I do a `masternode list`, I don't see the masternode that you show in your screenshot.
Also, the masternode that you set up; have you received any rewards on it?
Also, if this is a fork of Dash, do we need sentinel?
I can't get a masternode to start. In the controller wallet, it will start and show PRE_ENABLED, but it won't ENABLE. In the remote masternode, it won't show that the masternode has been started which means that the signal is not propagating on the network. It will just give ""Not capable masternode: Masternode not in masternode list".
Even when I started the masternode in the controller wallet, it didn't propagate the annoucement onto the network. Check "masternode list". There's nothing there, so you're masternode isn't being broadcast.
I've set up many masternodes before and I just can't get this one working.
Advice, dev?
We have setup masternode only on linux vps without windows wallet.Since you need VPS also when you are setting up masternode with windows wallet it's better if you do everything on VPS.
1. Setup and start wallet daemon
2. Generate MN1 address and send 5000 to that address from your wallet
3. Follow instructions from the guide
- Generate MN private key on VPS
- Get masternode output from your wallet
- Edit bitenx.conf and masternode.conf
- Encrypt wallet
- Start wallet daemon (bitenxd)
- Check if masternode works (bitenx-cli get masternode status)
This masternode is made following guide we posted.
Even when I started the masternode in the controller wallet, it didn't propagate the annoucement onto the network. Check "masternode list". There's nothing there, so you're masternode isn't being broadcast.
I've set up many masternodes before and I just can't get this one working.
Advice, dev?
We have setup masternode only on linux vps without windows wallet.Since you need VPS also when you are setting up masternode with windows wallet it's better if you do everything on VPS.
1. Setup and start wallet daemon
2. Generate MN1 address and send 5000 to that address from your wallet
3. Follow instructions from the guide
- Generate MN private key on VPS
- Get masternode output from your wallet
- Edit bitenx.conf and masternode.conf
- Encrypt wallet
- Start wallet daemon (bitenxd)
- Check if masternode works (bitenx-cli get masternode status)
This masternode is made following guide we posted.
I don't know what you are doing wrong I setup masternode with guide I wrote above and when type masternode list I get this:
It synced in few minutes and now it's working.
Disable IPV6
Do you have ports open for 44445?
Do you have blockchain fully synced?
Do you have walletpassphrase?