i may just try and replace the ftdi chip
Before doing that, try shorting the center two pins on the unpopulated 0.1" connector labeled PROG. Pin 5 is MCU reset and pin 6 is ground, so it will hold the microcontroller in reset. If it's an MCU issue holding it in reset should cause the device to pop up on your computer as the FTDI chip will be able to connect. If it doesn't show up, it likely is the FTDI.
Ok I performed the test and it still came up as an unrecognized device. So that means it is the ftdi chip correct? And if so what is the mfg part number?