If you've got more questions, I'd try searching first. This thread and the dev thread can tell you pretty much everything, including the answers to all of today's questions so far.
I have been searching the forum for a dev thread for the terminus R808, unfortunately haven't found one specifically. I can figure it all out, I have a lot of toys ;-)
Anyway, I figured I would use medium velocity liquid transfer (less than 0.25 seconds/cm) across the highest surface area I could get, I wanted very little pooling time. So far so good. Figured I'd throw them up on one of my sites that I just set up last night for other projects I am doing (you can see site's not complete, have a lot of text to add lol). Two different flavours, Acrylic and PVC, I think I'll cut the thickness in half. Might change to 1/4" copper plate rather than aluminum as well for oil usage, water creates too much oxidization with copper.
http://dal-tek.com/hs2.JPGhttp://dal-tek.com/hs4.JPGI think this should work pretty well with a 300mm reservoir, 100 gph high flow/low pressure pump and a 14" x 7" radiator with dual 6" fans. It would be nice to have the regulator board cooled as well, but I'll look at that tomorrow.
Cheers
