I ordered a ASIC Blade a couple weeks ago and it was working spectacularly!... Until today. When I plug the power adapter in nothing happens, the LEDs on the chip don't even go on. I am pretty sure the adapter and the cables are still fine. Anyone know a solution to this problem? I am using an adapted 4 pin ATX connector from my PSU to power the blade.
If a fuse is blown:
It's a fuse that's soldered onto the top of the blade left of the green connector and has the letter "R" on it. It can be replaced by soldering a new one on. It can be "jumped with a 12Ga. bent copper wire" (BEWARE you could fry your blade IF a short or power surge occurs) It can be replaced with a traditional automotive type fuse holder by soldering one on.