Hi,
I tried today to start your firmware on 800M(bmminer880) the temperature sensor on the third Board stopped working, gave an error. As the temperature jumped to 88, 103 degrees, like lags. I'm stopping at 750M. Before that, a few days I tested 725M.
What about your meter?
What is the power consumption board for 800M and 8.8v?
And what about the setup for each board? I noticed (as I said before) some boards are able to take a good overclocking, some are not. For example, one board can take 700M only, the other 750M.
Yeah so Temperature sensor not working is common. More often than not if it doesn't work any of them work. I found it funny only 1 of yours stopped working. Could you send me your kernal log when it does that again?
Yeah 95-105ish is normal for 800mhz the factory defaults on the s9 thermal throttle at 120 but I have this set to the new bitmain firmware setting of 110.
I am going to use the meter today. I got to figure out how to properly do this haha... Since dc you can't just clamp you have to probe it and I am trying to figure out the best way to probe it. Or if I can use a clamp if anyone knows how let me know.