Hey, so I just got one of these this afternoon from my Chinese supplier (pretty good price too) but it is LOUD. I am trying to figure our how to edit the config file to set the fan at 65% since it was only running at about 36 degrees until I can build an enclosure for it. There appear to be 2 separate files, and I am not sure which I shuold try and change, or HOW to change it. Any help is appreciated.
Miner.json (importable)
cgminer.config
Anyone know what command line I use?
Currently I see this in the Miner.json:
"stop_lower_fanspeed_in":"100","stop_lower_fanspeed_out":"100"
but have no idea if I just edit that, or something else
Have not seen this kind of settings before, have you tried to adjust both of these to 65%?
"stop_lower_fanspeed_in":"100","stop_lower_fanspeed_out":"100"
I was trying to look at cgminer commands generally to see if I could add a command, something similar to
Here is what appears in the JSON file. I am assuming that what that means is that the intake fane is the "in" and the exhaust is the "out". I am just not familiar with these commands. Unfortunately I have to wait because I am short a PSU... I have a 1200W platinum HP PSU, with 8 6 pin connectors, and I need 9... I am sure I could just not run 1 hash board but I have never done that and have some concerns that it would may cause an issue...Thoughts?
lyra2rev2-cutofffanspeedin": "100", "lyra2rev2-cutofffanspeedout": "100",