Hello, I changed the firmware to batch 1 after 24 hours the miner was cut down and no indicator is working. Now I can not enter the admin panel of the miner. Can you tell what can be done about it?
fan running
heat?
Power working at all
?Yes fan and power supply working.
Do you think that I can try to recover from the SD card
Have you tried this method?
https://support.bitmain.com/hc/en-us/articles/115003595387-How-to-reset-miner-to-factory-settings-
(Depending on where your SD-cardslot is placed you will use method 1 or method 3, read instructions in link for method 1 and 3 to decide which alternative is valid in your case.)
Recover from SD-card should be last option, I think!