This is whats heppening right now. Strangly the psu fan doesnt move at all. The blade seemed to be powered, because i can access the configuration page. Cant figure out whats wront.
It looks like your chips aren't getting enough power. Status should be like:
Chip: OOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO
And you have
Chip: xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
It seems that your PSU is providing enough power for the Ethernet / control logic to work, but not the chips. The fact that the PSU fan is not spinning is probably because your PSU is at very low load (since the Blades aren't hashing).
How did you power the Blades, i.e. how many +12V and GND lines for each Blades, how many Blades and wattage of your PSU?