FINALLY today I received a new board via OC directly from yxt, now I've taken the old board out and put the new board in after switching over the mini blades and am trying to connect to it using 192.168.1.254:8000 but am unable to do so, I cannot even see the device anywhere in the wired devices section of my router!
Anyone got any advice on what I might be doing wrong here?? My routers subnet is 192.168.1.x
Do I have to flash this new board with some sort of firmware before I can use it to control the mini blades???
Your router isn't 192.168.1.254 is it? That was an issue I had when initially setting mine up.
Other than that, you might have to do a factory reset... strange though that you could connect with the old cube but not with the new boards.