Re: Official FutureBit Moonlander 2 Driver and Support Thread
Hi, i have a problem with my moonlander 2.
I have a Raspberry Pi3 and 2 Moonlander2 on a 20W powered hub.
After a bit of work, one of the two moonlander go to 0 Mhz. Sometimes after 10minutes, sometimes after 48 hours of good work.
I try to reset raspberry and change the hub with another one but the problem persists.
I try to change the frequencies from 600 to 796 but the problem persists, i don't change any voltage.
Do you have any advice?
Thank you.
I have a Raspberry Pi3 and 2 Moonlander2 on a 20W powered hub.
After a bit of work, one of the two moonlander go to 0 Mhz. Sometimes after 10minutes, sometimes after 48 hours of good work.
I try to reset raspberry and change the hub with another one but the problem persists.
I try to change the frequencies from 600 to 796 but the problem persists, i don't change any voltage.
Do you have any advice?
Thank you.
Try running each one alone at 600mhz. If they both run fine alone then the issue is with the hub.