Post
Topic
Board Hardware
Re: [Setup & Troubleshoot] Bitmain AntMiner S1 180GH/S miner
by
Billsonl
on 28/01/2014, 04:08:15 UTC
This is my current setup: 3 Wi-Fi Ants powered up by one 1400W Thermaltake
http://www.youtube.com/watch?v=pqwpn5Jns-A

how did you set up wifi without an antenna?

Actually I get pretty decent signal without antennas. They aren't necessary in most situations.

Can you share how you were able to set up wifi...i tried playing with it and couldn't get it to work and had to use RJ-45 cables.  It would be nice if i can use wifi so it's more mobile.  thanks for your help.

I made direct LAN connections first (laptop -> Ant), then Network -> WWAN -> Scan -> Connect -> set wifi password etc. -> save and apply -> and then go to interfaces -> find WWAN (name of the wifi network) and click Connect

thanks for your assistance, i was able to set up WiFi thru Ethernet connections.  Once WiFi is set up, i rebooted and remove RJ-45 cable.  Now it's hashing via WiFi.  I can see that it's hashing at the pool.  But I have one minor issue, I can not access the web interface using the WiFi ip address, it loads up for "LuCI - Lua Configuration Interface" a second but then get the "can not connect" error message.