Post
Topic
Board Hardware
Re: Open Source Avalon Gen2 55nm Board
by
hongkongapple1
on 30/01/2014, 17:26:11 UTC
Ok, what I did:
- bought Pickit3, downloaded MPLAB X, installed it
- download latest firmware once from
     github.com/formtapez/avalon and from
     github.com/zipiju/k16-firmware
-connected Pickit3 to computer, drivers have been installed
- started Pickit3
- choosen as device: PIC16LF1459
- pressed connect
- warning window pops up to check wether the choose device is correct or not. => checked it chip on board
   is PIC16LF1459 => pressed ok
- warning window pops up: Target Device ID (0x0) does not match the expected Device ID (0x3027). Would
  you like to continue? => press ok => CONNECTION WILL BE ESTABLISHED
- choose downloaded .hex-file => press Program
- error message comes up: failed to program device

What am I doing wrong? For me it seems that I have the .hex-files? Is this correct?

Does hongkongapple1 gave is latest firmware to anyone of you? I asked him twice for the .hex-file for 25GHs and he gave me no response nor the files.

Can anybody help me a little bit?
 

NO one yet have the firmware ~  not even the people who have contribute me & great Minepeon Patch ~ 
Not even those who have bought 10+ unit ~ 
As the firmware is not in a releasing stage yet ~ 
Also I only help on providing the Hardware ~  ( Not software )  this is a project -  where anyone contribute some part ~

So what is ur part ?   U can't even flash a firmware which "form" already provided ~   

pls do not expect anyone will answer ur question ~  as I don't think they will just give out instruction which is already known !

Thx ~ for the blame ~  but again I should mention it ~ " I don't provide the firmware "   

It will be release when it is already, or while there is that I have gather enough interest ~ pls read & all the messge before asking ~

And pls read the Manual from Microchip ~  PICKIT

read about the what the errror message have tell u !!   as I remember the messge will tell u to set the compiler properly !   

I HAVE ONLY SET IT ONCE,  AND I DID IT WITHOUT EVER HAVE THIS KNOWAGE B4 ~ SO I WILL U CAN DO IT TOO ~~ 

This is a PROJECT, what u have to expect is KEEP TRYING UNTIL U GOT IT ~