Post
Topic
Board Hardware
Re: [Setup & Troubleshoot] Bitmain AntMiner S1 180GH/S miner
by
BTCsovjet
on 31/01/2014, 18:05:42 UTC
Reboot.   It might hang.  Then power off and on again. Then log in


Tried it several times :/

After you reboot and login, go to the network tab and verify that the wireless is being issued an IP.

This is the info from my Network page. Any ideas?

System
Hostname   antMiner
Model   TP-Link TL-WR743N/ND v2
Firmware Version   OpenWrt Barrier Breaker r38031 / LuCI Trunk (svn-r9909)
Kernel Version   3.10.12
Local Time   Mon Dec 2 06:09:09 2013
Uptime   1h 41m 22s
Load Average   

Network

IPv4 WAN Status

eth1    Type: static
Address: 192.168.1.241
Netmask: 255.255.255.0
Gateway: 92.32.217.20x
DNS 1: 8.8.8.8
Connected: 1h 33m 8s

Active Connections   593 / 16384 (3%)


DHCP Leases

-empty-

Wireless

Generic 802.11bgn Wireless Controller (radio0)   
[Signal: -75 dBm / Noise: -94 dBm]
50%   SSID: GN_private_6x
Mode: Client
Channel: 11 (2.462 GHz)
Bitrate: 1 Mbit/s
BSSID: 00:01:38:89:FB:C6
Encryption: WEP Open System (WEP-40)

Associated Stations

MAC-Address 00:01:38:89:FX:X6   Network Client "GN_private_6x"    Signal -75 dBm   Noise -94 dBm   RX Rate 1.0 Mbit/s, MCS 0, 20MHz   TX Rate 1.0 Mbit/s, MCS 0, 20MHz