Fan control still needs work.
Got the alert from litecoinpool that the apollo had dropped off this morning. I could not get the the web front end, so I ignored it figuring on a crash.
The L3+ that is on the same power supply never dropped so I knew the power and internet were good.
Got in to work and fan was not spinning AND unit was about 1 billion degrees (give or take a bit) was actually hot enough to darken the thermal ink label on the controller.
Once it cooled down it seems to have come back no problem.
I now have the fan set to 25% instead of auto.
In the next revision can you have the fan fail to max speed in case of any issues?
-Dave
Got the alert from litecoinpool that the apollo had dropped off this morning. I could not get the the web front end, so I ignored it figuring on a crash.
The L3+ that is on the same power supply never dropped so I knew the power and internet were good.
Got in to work and fan was not spinning AND unit was about 1 billion degrees (give or take a bit) was actually hot enough to darken the thermal ink label on the controller.
Once it cooled down it seems to have come back no problem.
I now have the fan set to 25% instead of auto.
In the next revision can you have the fan fail to max speed in case of any issues?
-Dave