Question 1: Will you be pushing firmware updates without any manual component, meaning if I follow these instructions the firmware for my device will be updated without any warning and I will not even be notified?
Question 2: Will the updating of firmware occur for all devices that I have hooked up to a single Rpi? Meaning if I have 10 babyjets all plugged into one USB hub which hub is plugged into my RPi will the firmware for all 10 devices be updated?
Answer 1: Yes, we will push the firmware and software updates whenever they are ready. If you do not want to accept them, you can uncheck the "Enable HashFast updates" box on the settings page of your RPI's web interface and then at your choosing perform a manual update.
Answer 2: We don't advise running that many units on only one RPI, it's likely a bit too much load for the little guy!
We are going to test the update mechanism to be sure it will update everything reliably and won't break anything, though I don't think we'll test any more than 3 systems on one RPI. Worst-case is you might have to unplug some units and restart the RPI a few times with only a few units connected.
Our goal is to get you the most uptime possible, so we're going to tune the update process to be a smooth as possible and require no hassles if we can help it.
-Phil