V1.8.4
- Performance increase for Vega56/64/Fe/Vii up to 15%!
- Minimum for 'main_pool_reconnect' is now 60 seconds instead of 180
- Added new cmd parameters: --disabletweaking, --cgputweakprofile
- Added new config parameter: tweak_profile
- Minor bug fixes


+ Yes, you read it right. Performance increase on ALL algos on Vega56/64/Fe/VII up to 15%!
A new parameter 'tweak_profile' was added, which if used can significantly boost your hashrate. There is section about this on the first page, but in short:

There are 5 (6) profiles, where :

0 - no change, uses your original settings
1 - light tweak
2
3
4
5 - max tweak

You should find separately for every gpu the profile it can handle, and set it in gpu_conf or cmdline.

VERY IMPORTANT :
1. Miner must run with administrator privileges [right click on SRBMiner-CN.exe->properties->compatibility-> check 'Run this program as an administrator' option-> click OK button
2. Don't apply any memory timings with ElioVP's tool before running miner
3. Don't start testing/tweaking with your highly optimised PPT and ODT settings - because it is probably optimised for a miner/algo combination.. Start with stock settings.
4. Be patient, it takes some time to find settings optimal for your gpu/rig

Tweaking is enabled by default, and can be used on supported devices.
If you want to disable it use the --disabletweaking parameter in start.bat

It can't get easier to use, just use + and - on your keyboard to move between the profiles.

Examples on how to use it can be found on the first page.

Special thanks goes to ElioVP for sharing the offset of the timings position.