Hello everyone ,
I am here again with another problem
I was trying to update my s9j control board with sd card
As bitmain instructed I downloaded T9+ firmware ,copied files to sd card inserted it then I shifted jumper number 4 and turned on the control board
after both green and red led were blinking as it should , I turned off control board put jumper 4 to default place ,and remove sd card . but now I can not connect to miner interface i tried to use ip scanner , or ip reporter but couldn't find IP address of miner, what should i do ?
I am here again with another problem
I was trying to update my s9j control board with sd card
As bitmain instructed I downloaded T9+ firmware ,copied files to sd card inserted it then I shifted jumper number 4 and turned on the control board
after both green and red led were blinking as it should , I turned off control board put jumper 4 to default place ,and remove sd card . but now I can not connect to miner interface i tried to use ip scanner , or ip reporter but couldn't find IP address of miner, what should i do ?