Post
Topic
Board Hardware
Re: [Setup & Troubleshoot] Bitmain AntMiner S1 180GH/S miner
by
smithytzu
on 15/02/2014, 06:29:04 UTC
Ok, so I was able to factory restore by following directions on here, but now I am back to my original problem.

I am following the directions in the op, but when I manually input the ip address into IPv4, my computer cannot connect to the internet. I can interface with the antimner without changing my ip settings by navigating to 192.168.1.99, but it is not mining after I input and ave my pool settings.

What's your modems IP address?

Go to the ant miners network config page, make sure the gateway (your modems ip) is correct the primary DNS should also be your modems ip, go to the ant miners network diagnostics page and run both ping and DNS tests, if they work you're antminer is connected to the internet and good to go.