If anyone in QT has trouble seeing their sanc list in the GUI, please reboot and ensure they are started.
all Sancs are in pre-enabled status in controller GUI .
running "masternode status" on the Sanc returns " "status": "Not capable masternode: Masternode not in masternode list""
attempting to start a sanc from the controller doesn't do anything .
I did try rebooting the sanc and re-downloading the blockchain as well .
It didn't help either.
blockhash on controller and sanc:
19:02:46
getblockhash 129427
d053f86021908481059fbc65b5e8d257882c1d5cb5f097a0d949fef8cfdca947
Looks like they are coming back up now; about 140 out of 182 have re-propagated into the active sanc list (I think this takes about an hour).
I just tested one that I started (in my case I pushed Start-All), then went to the sanc itself, and it did start (masternode status) is fine now.
On a side note in this case no one should have to re-sync the whole chain, its just a re-synchronization issue of the masternode list data.
(IE mnsync reset will also help).
I think in an hour or two we will see 90%+ coverage again in enabled.
as of now at 128469 I can see only 4 sanc in "ENABLED" status .
the rest are mostly "expired" .