Re: How to upgrade TPLINK TL-MR3020 firmware to technobit openwrt
This week I bought one MR3020 and flashed it with the technobit firmware (openwrt). Everything worked fine until the switch of the lan interface to dhcp.
The MR3020 started, but no connection was possible. Trying to switch the MR3020 into failsafe mode failed - neither by pressing the WPS button or by change the position of the sidemounted switch. So I bought a CP2102 and followed this guide (no additional resistor was needed).
Afterwards the MR3020 worked again, but this morning the usb psu was defect and I had to use one of my phone usb charges. In the end, I am starting to hate the MR3020.
The MR3020 started, but no connection was possible. Trying to switch the MR3020 into failsafe mode failed - neither by pressing the WPS button or by change the position of the sidemounted switch. So I bought a CP2102 and followed this guide (no additional resistor was needed).
Afterwards the MR3020 worked again, but this morning the usb psu was defect and I had to use one of my phone usb charges. In the end, I am starting to hate the MR3020.