In order to overclock your Bitmain AntMiner S1 ASIC to provide 200 GH/s and low HW Errors rate with our settings you need to follow the steps below:
- Login with SSH to your AntMiner S1 ASIC using the IP and username/password youve set it to use.
- Type cd /etc/config (without the quotes) in order to get to the folder where the config file is located on the miner.
- Type vi asic-freq (without the quotes) to edit the config file, comment the currently set options by placing # in front of them and add the following lines or directly replace the values with the following ones:
option freq_value 5f05′
option chip_freq 393.75′
option timeout 36′
- Save the changes you have made and type reboot (without the quotes) to restart the miner, so that it can apply the new settings and start mining at 200 GH/s with the overclock settings youve set.
The Antminer Asics will be running at 393.75 Mhz
Make sure you check your temperatures after 30 minutes and ensure they are under 50 degrees c
I am running 8 x ant miners on individual Corsair CX500M power supplies at this rate for over 2 days now
Good luck.