Would it be smart to glue it with thermo adhesive cpu past in the mean time until i can change it? Would that help in any means?
Heatsinks on these miners are not attached using adhesive. Instead, the heatsinks are soldered directly to the top of the chips with low-temperature melting point solder (138 deg C). Using thermal adhesive to attach the heat sink to the chip may work, but it might be extremely difficult or impossible to remove it once it's on.
Zeusbtc has listings for independent repair centers on their website you could try contacting (bottom of this page
https://www.zeusbtc.com/Repair.asp).
Got ya thanks!
I’ve sent them an email to.
Could anyone help me make a minimum requirement list for equipment need the change chips on boards. Would like to start trying it out since I a ton of s9 dead boards.
Would prefer with equipment from Europe
Thank you!