Do you need corrected BOM ? I can send you one...
Yes, please!
...
On the BOM I selected an alum cap, P15077CT-ND, for C500, C501... Obviously they didn't mean to use an LDO converter and I don't think they meant an axial cap either. I think was the biggest misprint. Also, I have plenty of right angle pci-e power connectors and plan on soldering them on the underside of the board(backwardz) so polarization is still correct. I couldn't seem to find the upright ones.
...
What did you do about L1, L2? They're marked at 470 nH in BOM, but 200 nH in the schematic
...
I use Mouser for those. Digikey doesn't stock them as well. Part number 45558-0003. Also the upright connectors in the BOM don't match the pitch I measured in the gerbers, so the part is completely wrong. The pitch does match the part number above though.
Just checked looks like Mouser has upright connector with correct pitch as well. 45718-0002
...
Nice job on finding those, I thought I'd searched all the way through but didn't find them other than on Digikey. But the pins on these don't match either. On digikey the pitch is 5.3mm(long side)/5.3mm(short side), on mouser the pitch is 4.2mm(long)/4.2mm(short), the actual measurement is 4.0mm(long)/5.0mm(short). I suppose one can bend the leads to make them fit...
...
The boards have an IN and OUT SPI connection am I right in thinking that I can for example connect 3 together and run and Raspberry PI or am I missing something?
...
I believe you can, unless something gets in the way (like as a heatsink)