Hello. There is a problem: There are several rigs composition; win10, cards RX 580 8Gb, mother Asrock 81, driver 20.9.1 If after rebooting immediately turn on Phoenix v5.2c then the speed from the card is 30mh/s, and if you first run the nanominer v1.12.0 and then Phoenix, the speed on fenex rises more than 32mh/s and keeps stable. If the rig is reloaded, it will be 30mh/s again. To get 32mh/s, the operation with the launch of the nano miner must be repeated and then again it will be 32mh/s. Currently, no additional parameters are registered. If you pre-launch the nano miner only on one map, then the speed will increase only on one map. If you put strap 1 on the map where the speed is already 32mh/s, then the speed drops to 30 mh/s. What could be the problem? Which parameter should I add or change? This pattern always works on different rigs.