hi,
i'm new on TRM. i have 4 vega red evil 56 card hynix ,with my settings from claymore i get a hashrate on 43mh/s
930mhz mem 1050 core on 900mv can't get the mem higher.
i try modded the mem timings with the amdmemorytweakxl tool.
i always get the 43mh/s
i'm not sure i've im doing it right. try the changes from the ethgenreraltuning list in tweak tool. apply.
does TRM auto tuning reset this settings? or do i have to add anything in the command line?
thy
The 43 MH/s is the classic limit at stock timings, so it really sounds like the changed timings aren't being applied properly for you. The miner doesn't touch anything related to clocks/voltages/timings, only the fan curve if you have fan control enabled.
It's hard to say why the timings aren't being applied. If you start the miner and let it run for a few mins, then open amdmemtweakxl and e.g. boost tREF to 17000 or make a slight adjustment down for tRCDWR and apply the changes, does the hashrate move in the miner? If not, what timing are displayed of you close+reopen amdmemtweakxl, are your changes there?
hi, thx
now i got 46 mh/s with 1700 on ref and 20rcdrd and 4 rcdwr. there was no diference with rcdwr starts on 10.
does the settings from tweak tool reset after pc restart? watchdog is enabled with restart the system.
can i set a target temp for fan with command line ? or just settingfan speed?
My bad, I wrote rcdwr but really meant rcdrd. That's the one you want to lower slowly. Also, did you do 1700 or 17000 for ref?
For fan control, you can target a core temp, junction temp, or mem temp, set the initial fan speed or a static fan speed. Use
--fan_control --fan_default_vega=::70:60 to target 70C mem temp with fans initially at 60%.
I start with 17000 on ref an go down to 18 on rcdrd but it was not stable. ref is now on 15600 and rcdrd 20 is stable for a few hours. hashrate is 46mh/s. i set the target temp on 55
But on restart the settings are lost.
thanks a lot!
one more question. i now run the vegas with ref 15600 rc 35 rcdrd 19 get 47 mh/s hashrate when auto tune set konfig on a1024.
but autotune set is not erverytime the same for example now 1 card is on eth config a736 and there are only 44mh's hashrate . Same cards with the same settings.
Can i set the eth config fix in the command line? or start autotune new?
and i need help with a batch file for amd tweak tool for startup i've the amdtweaktoolxl and i wrote
(folder of tweak toolxl...).exe --i 0,1,2,3,4,5 --rcdrd 19 --REF 15600 --rfc 164 --rc 35
it opens the tweak tool but didn't set any settings?
thx