Rig with 5 rx 5700 xt with settings vram clock speed 1800 to 1810, core 1300 to 1350 MHz and voltage 725 to 800 mv , win 10, amd driver ver 20.4.2. Test it at f2pool, ethermine and nicehase. With teamredminer had no problem at all, no problem at all for 5 days continuously. With phoenix miner 5.4c and 5.3b I had the same problem, when the phoenix was starting after a while (from 1 or 2 min to few hours) 1 or 2 gpus they showed 0 mh while the phoenix continued mining with the other gpus without any message and the volt from the gpu that shows 0 Mh drops to 20 watt at the software and about –100 from the wall.
Any idea why it does this and how I can fix it?
yes I have an idea how you can fix it - stick with your teamredminer - continuously.
The thing is that with the same settings and the same watts from the wall, the phoenix has 55.5 mh on each card and the teamred has 54 to 54.3. I have seen that what the miners report in software is also reported in the pools. 1 to 1.5 mh per cart per day for 5 gpu may not say much, but over time it is a significant difference. So if I manage to stabilize phoenix it would be good. Of course I will prefer stability from the few mh above.
So anyone some idea?
Don't use cvddc, cclock and mvddc. Set it to 0 for each card and use only mclock and powlim. If you use msi ab use it only for fan control.
-cclock 0,0,0,0,0
-cvddc 0,0,0,0,0
-mclock 1800,1800,1800,1800,1800
-mvddc 0,0,0,0,0
-powlim -40,-40,-40,-40,-40 (some gpu can work with -45 or -50 but some gpu can't work even wit -40)
Thanks for the reply.
I do not use any of them in the bat file. For gpu control I use only AMD software. In the bat file I have only the main points such as pool, wallet and worker. The power limit of all gpus is at 0%. Should I add clock, cvddc and mvddc at bat file with 0?