I have reset and rebooted the nuc multiple times, it always reports 0 chips / ZOMBIE mode. What I have also noticed is the LED inside remains solid amber, I never see it flash as it does on the other one.
Right now I am just going to leave this unit unplugged. Will try it again in a couple hours.
Could the unit have failed?
Just came here again after months looking for a solution and noticed your post. I have tried everything I can think to resolve the "0CHIPS/ZOMBIE" issue, but 2 of my 606's will not mine beyond approximately 30 minutes. 2 of my 3 units have been 0 CHIPS, and 1 of 2 is units is brand new.
The suppliers have been very kind, but I still can't get them running. My
3rd unit has run near perfect at 1TH for a year with normal typical issues and I am very pleased. I hope collectively we can figure this issue out.
So now the second unit failed, it was reporting zombie - I shut everything down, waited 5 minutes, powered it back up and now it isn't even detected by the pc. Do these fail this often? From what I am reading here I don't think I am running anything that shouldn't be stable. Currently I have been running Setting 5 @ 700 Mhz averaging 950GHs.
What else could be causing this?