yeah what else can we try.
the eth cable goes to a switch?
do you have a pc or laptop to the same switch.
and of course does angry ip or advanced ip show the range
say
192.168.0.1 to 192.168.1.255
with no new ip?
did the fault light ever fire up and blink?
or the light below it
Did the seller say he did stock firmware from bitmain?
or did he have after market firmware.
if they had loaded aftermarket it is hard to know what to do since you do not know what is loaded.
My network (Xfinity) is 10.0.0.1-10.0.0.254, today (5/21/2021) I have searched with Angry IP Scanner, Advanced IP Scanner, and the IP report tool and does not show anything, no new IP addresses.
RIGHT as soon as I plug it in to an electrical port, the Fault light will blink for about 0.5 sec and then stop, the "Normal" light does not blink at all.
Seller said he had it on stock configuration and then suggested the Blissz configuration.