When I run one of my L3's it shows a pretty steady hashrate of ~520 which is pretty close to the stats page on the miner. However, if I add another one of my L3's, both rates drop and fluctuate from ~450 to ~480 each.
Unit 1 shows ~520
Unit 2 shows ~510
Unit 1 plus unit 2 shows ~950
I'm getting ready to add a third into the mix to see what happens. But, is there something I should be doing differently?
It's not that straight forward.. The firmware gives you a rough estimate of the hash rate the miner is doing. The Pool shows the hash rate that its registering from the miner over the network.
For example .. one of my miners registers 620 on the miner, but i have seen it spike up to 700+ on the pool. Then it might go as low as 580 according to the pool. the fluctuation is normal. It also can differ from pool to pool.
I came across an article a while ago that explained it better but i cant find it atm.