Re: [Setup & Troubleshoot] Bitmain AntMiner S1 180GH/S miner
Thanks, Winterdeath the above post is about me ^^
OK I got my hands on an antminer S1 and I ran into a weird problem. I got it set up and had trouble with my all in one gateway/modem communicating with it so I went into my router controls and made my gateway 192.168.1.1 and logged into my antminer's ip just fine. I changed the pool to my multipool address and hit save and apply and rebooted the antminer. About 2 mins later it began hashing, but when i checked the miner status tab in the interface it said it was mining for http://50.31.149.57:3333, which is the default pool 0 in the antminer settings. Now I went back into the miner config and entered my pool info again to make sure it wasnt an error and when I hit save and apply and rebooted the miner it does nothing at all
I reset the miner with the button and it mines on the default pools just fine, showing 180ghs on the miner status tab, but when I change it to my pool it only beeps. When I turn off the power and turn it back on it stops beeping but will not hash. I tried the same pool/worker combo on a smaller bfl miner and it works fine so im entering all that correctly. I dont know what it could be
also my ipconfig has a lot more parameters than the one in the tutorial, theres one for local-link ipv6 address above my ipv4 address mask and gateway
OK I got my hands on an antminer S1 and I ran into a weird problem. I got it set up and had trouble with my all in one gateway/modem communicating with it so I went into my router controls and made my gateway 192.168.1.1 and logged into my antminer's ip just fine. I changed the pool to my multipool address and hit save and apply and rebooted the antminer. About 2 mins later it began hashing, but when i checked the miner status tab in the interface it said it was mining for http://50.31.149.57:3333, which is the default pool 0 in the antminer settings. Now I went back into the miner config and entered my pool info again to make sure it wasnt an error and when I hit save and apply and rebooted the miner it does nothing at all
I reset the miner with the button and it mines on the default pools just fine, showing 180ghs on the miner status tab, but when I change it to my pool it only beeps. When I turn off the power and turn it back on it stops beeping but will not hash. I tried the same pool/worker combo on a smaller bfl miner and it works fine so im entering all that correctly. I dont know what it could be
also my ipconfig has a lot more parameters than the one in the tutorial, theres one for local-link ipv6 address above my ipv4 address mask and gateway