Quote from: honglu69 on November 02, 2021, 11:08:36 PM

Full Node Syncing Problem

This issue apply for all full nodes, solo miners or pool miners etc.

Posted byu/Sokka2015
3 hours ago
Live node problem
Hello Nengsters!

There was an issue regarding node syncing and it has been resolved. For those having node syncing problems check block explorer and put some addnode using live-node board, do "dead chain" procedure as usual in our reset times if needed if the node can not sync.

Block Explorer link: http://nengexplorer.mooo.com:3001/

-----------------------------------------------------------------------------
honglu69
·
just now
For those nodes miners that do not have any clean chain data available from another node, do this below to re-sync from beginning to end to get correct chain:

./nengcoind -reindex

To speed up syncing and target correct nodes source, you can max out for only two connections, any two with correct blocks and addnode in "nengcoin.conf" file and delete other nodes to insure no interference from other wrong nodes:

------------

upnp=1

maxconnections=2

addnode=71.234.69.93:6377

addnode=185.182.8.67:6377

addnode=209.145.50.223:43768

----------

really.................. so... you screw with the difficulty to you can try to make a CPU mineable scrypt coin..... THEN... the chain doesn't form a chain because the difficulty of the blocks being solved is too low and causing it to throw an error...........................you have no idea what you are doing.. all you had to do was change the amount it will vary during a diff reorg. ... and change the frequency it will reorg the diff from every n blocks to every block...... OR stop screwing with it to try and gain an advantage