Post
Topic
Board Hardware
Re: GekkoScience has a new stickminer that does 300+GH
by
n0nce
on 29/07/2022, 00:08:47 UTC
Another question, can you tell cgminer the mhz for 1 specific stick? I have a usb hub that does not support the sticks at 450mhz and I would like to leave these with a smaller mhz, but cgminer tries to keep increasing the frequency to the programmed 450mhz.
Can't check it myself right now, but there are some options to make cgminer not connect to all sticks, but only certain ones. Then run a different instance of cgminer for each set of sticks (or one for each hub / however you 'cluster' your sticks), specifying the frequency and other settings you want to apply to this selection of sticks. You could even optimize every stick on its own and run one instance per chip to get best results.

[...]
--usb <arg>         USB device selection
[...]
--gekko-serial      Detect GekkoScience Device by Serial Number