Ran the update this morning, which is now stuck at "Hold on, page will reload in a few seconds..." It's been at that stage for over 30 minutes. What should I do if anything? Also I am just now reading about flashing the drive, which I know nothing about. I think my Apollo's are batch 3.
Edit: refreshed page, update seems to be complete. However I'm unable to move forward with the flash process as I cannot get Etcher to run even when setting permission to do so.
Hope to still get the team to help with updating the flash. The Apollo won't open any AppImage files, even if they are set correctly to do so. Double clicking to run the program only results in a spinning wheel for a number of seconds, and then nothing.
Satayasat- while perhaps obvious to most, those of us less technically inclined read the MCU Flash Instructions verbatim and ran into the same problem: Apollo wont run the balena-etcher-electron-1.7.9-linux-ia32 file. Power down the Apollo, remove the microSD card and perfom the flash instructions on a
different computer. Re-install, power on, and re-configure passwords and settings as on initial device setup.