Ninjastic
PostEdited versionsQuotes to this post
Post
Topic
Board Hardware
Re: Which USB hub to use with Block Erupters | NanoFury NF1 | BPMC Red Fury | Ant U1
by
oskuro
on 15/04/2014, 22:27:40 UTC
Quote from: vs3 on March 15, 2014, 08:48:57 PM
Quote from: vs3 on February 20, 2014, 07:45:38 AM
Quote from: Rawted on February 20, 2014, 07:21:09 AM
Amazon has their own custom built 7 port usb 2.0 hubs with 5v/4a adapter for $19 shipped (prime). Ordered 7 for an antminer project, i'll report back how they work out.

http://www.amazon.com/gp/product/B00DQFGJR4/ref=ox_sc_act_title_1?ie=UTF8&psc=1&smid=ATVPDKIKX0DER

Actually they were $12 at some point ... I should've ordered more of them at that time. I've been using them for testing various quantities of NanoFury boards and so far they've been performing pretty well.

A follow-up :

I've been using those Amazon ones for testing of the dual-chip design and I am very impressed by them - I've plugged them into USB3 ports and 3 miners are happily hashing there when pushed to the limit.


And a very disappointing observations from this one: http://www.newegg.com/Product/Product.aspx?Item=N82E16817111981
(and there are a lot of similar ones with 2.5A power brick)
The power brick is a piece of junk and as soon as you add some load to the hub (let's say 1-1.5A) the voltage drops to 4.6-4.7V and if you push it even harder it goes even below 4V.
This was a nasty surprise for my desktop which in essence ended up having to provide all the power as that power brick's voltage was well below the PC's 5V.

Hi do you recommend me that  usb hub for mining with antminers u2+? or what usb hub can you guys recommend me? because antminers u2+ have heat sink and are harder to fit Wink thanks