Hi Everyone. Just received and setup my Apollo Full Node miner. Its running fine, and connected to the pool but the whole OS will freeze after about 45-60 minutes. No mouse control, no keyboard input. The red light on the Apollo is still blinking, but it doesn't connect to the pool anymore, no hashing being reported. The only way to get it back is to flip the switch off, and then flip it back on. It freezes even if the miner is off, and yes its still syncing the blockchain, but if its going to keep freezing even without the miner running its going to take more than 48 hours to sync this blockchain. Its not hot to the touch really, but with the miner on its temp is about 76 C.
Any ideas on why this would be freezing and what can be done to fix it?
I think I may have figured it out. It appears that the thermal/temp sensor was flopping around inside the case, as in it was just dangling near the bottom, so it wasn't taking proper readings of the temps. I took off the right side panel, and sort of wedge it in as best as possible next to the plate that the CPU heatsink sits on. Not really sure if that is where it goes or not, but so far the miner has been running without issues for a few hours now. I ordered some thermal tape and plan on taping it into place so that it doesn't start flopping around again.
Anyone have any ideas where exactly the sensor is supposed to be located so I can put it in its proper place?
I think you might have moved the WiFi antenna, not a temp sensor.