Awesome, yeh I just noticed they said extra heat dispense stuff is needed, they must do a good job to get 1200mhz with the same results as the lower resistor, I am guessing it will probably be at 530khs - Well you know what I have in the mail, 15mmx15mm square 1mm Copper shrims
And some good thermal past better that that silver stuff...
just wondering though with the shrim how would you recommend placing it on the chips? would you do 5 shrims per device and put thermal paste between the shrim and the chip and also between the shrim and the seed heatsink?
What do you think?
Maybe use 1.5mm instead of 1mm? (I read the height of other components are not allowing a good contact with the heatsink)
What thermal silicone paste are you using or do you even need any with this
pad?