So where on this gridseed do I find the measurement point for the voltage?

Just for the hell of it and since I couldn't sleep, I did the bridge mod, then wired up a 50k pot to the 36K resistor that corresponds to VID1 (Voltage = 1 parameter) and a 50K pot to the 33K which corresponds to VID0.  Since I know someone may ask...I removed the stock resistors.  I set them both to stock resistances and noticed some odd behavior.  At 800Mhz it seemed that without the Voltage=1 parameter the pod would hash away, get no accepted shares, and accumulate hw errors.  At the same 800Mhz speed using the voltage=1 parameter the pod would hash away, get accepted shares, and still accumulate some hw errors.  Not as many as without the voltage=1 parameter, but still errors all the same.  


It could be that my pod is just going to throw hw errors due to some damage when the mosfet blew...so someone else may need to give the idea a shot and see how it turns out.

*edit*  - yep...even with the 2 50k pots set to the stock gridseed values of 33k and 36k, and the clock speed dropped back to 800Mhz it generates errors at a frequency of about 1 per minute.  Client side hashrate shows ~350kh/s but poolside shows around 327kh/s.