Good afternoon guys- weird problem any ideas?
I have been running 3 old T15s on the pool for over a year and a few months ago I upgraded and got a used S19j Pro 96T and been running that instead for better power efficiency. Just for fun I popped over to a SHA256d MAZA Solo pool yesterday so I get the thrill of seeing a few blocks of something get found by my miners. The Difficulty was only 9M and the time to find for my ~100 TH was supposed to be less than 2 minutes but I let it go for 3 hours with nothing to show   and other miners with only 20 ish TH were catching all the blocks-it was showing correct hash rate and millions of shares accepted... I switched to my old test-unit T15 with only one hash board (7TH) and BAM I hit a block ... then after 20 minutes another, and another. I put the S19 back on and nothing again for hours... never hitting anything.
>>Now I am worried that this S19 miner can't or doesn't report found blocks...The T15 has CGMINER version 4.1.11.1 rwlhr, But i can't see the version in the S19.  I upgraded to the newest stock firmware but no help.
I know this issue didn't happen directly on this pool BUT I don't want to run a miner on this pool that can't report a found block.. Is there a test pool using CKpool software I can try to test my unit? Do I need to setup a CKpool instance for testing?
I want to verify that the miner does report blocks found-

>CK does the CGMINER software running in unit report found blocks above the target  or does it report everything and let the pool figure it out and report it?

Thanks